1980 - 1986 Ford Truck F-series A/C System

1980 - 1986 Ford truck a/c system.  This a/c system is designed to fit into the truck without altering the stock heater box, or glove box.  The evaporator unit sits above the heater box with the hoses exiting out the firewall where the factory designed them to exit.  The vents have to be cut into the dash, just as the original Ford truck was designed.  The panel goes above the glove box, the new panel will have the vents installed into it.  The a/c controls are two rotary knobs that get mounted in the dash or under the dash.  This kit will give the truck the orignal look of factory a/c, and it will cool the inside of the cab without any problem.

• The kit is complete and includes the following:
  
• Evaporator kit with expansion valve and mounting hardware, grommets
• Duct hose and vents
• R-134a Hose kit (See hose kits page for contents)
• Black oring drier with drier straps
• 14 x 25 Condenser with condenser mount kit 
• Sanden Style A/C compressor with clutch
• Compressor mount kit with belt, pulleys, and mounting hardware (to fit your Ford engine)
• HI / Lo binary pressure switch
• Directions

If you prefer a different size condenser please specify the size in the checkout section.   The unit cannot use the original heater control panel because it has a seperate blower motor for the evaporator.   The picture of the bracket mounting to the dash, is how the units is held into place.  The dash pad is removed from the vehicle.

Please specify the year and engine size of your truck during the checkout section.