GM LS-2 Compressor Adapter 90 Degree

This is a 90 degree adapter that will allow you to use the stock compressor on an LS-2 engine with an aftermarket air conditioning system.  The adapter is designed to fit onto the back of the compressor with two male fittings to hook onto an aftermarket a/c hose kit.   The hoses will point out the to the rear of the compressor.

The adapter's specifications are:

•     # 8 discharge fitting / high side 3/4"-16 male oring fitting
•     # 10 suction fitting / low side 7/8"-14 male oring fitting
•     Center on center mounting holes (side that goes into compressor) ~1-1/2"
•     The block without fittings is one inch thick.

This block is the simplest way to adapt hoses to a LS engine compressor.