GM LS-2 Compressor Adapter 90 Degree Forward / Down

This is a 90 degree adapter that will allow you to use the stock compressor on an LS-2 engine with an aftermarket air conditioning system.  This adapter will allow you to route the hose forward or down off of the compressor.  The adapter is designed to fit onto the back of the compressor with two male fittings to hook onto an aftermarket a/c hose kit.   The hoses will point out the to the front of the compressor.

The adapter's specifications are:

•    # 8 discharge fitting / high side 3/4"-16 male oring fitting
•    # 10 suction fitting / low side 7/8"-14 male oring fitting
•    Center on center mounting holes (side that goes into compressor) ~1-1/2"
•    The block without fittings is one inch thick.

This block is the simplest way to adapt hoses to a LS engine compressor.